YX50-160 TOP BEAM ROLL FORMING MACHINE
2.0mm Minimum Thickness, 4.0mm Maximum Thickness
3.0mm for inspection
Galvanized Steel Sheet
Yield strength: Q345B
Feeding width: 470mm
ATTENTION: the below overall dimensions should be double checked.
5Ton*650mm Hydraulic Un-coiler
Hydraulic system to expand coil inner hole;Pump motor:
Frequency Inverter to regulate turn speed;Motor:3KW
Coil Inner-diameter= 470-560mm. Coil Outer-diameter Max. 1600mm;
Link-connect expanding system
Load Capacity: Max. 5 Tons; Coil Width Max. 650mm;
Hydraulic Holder on the top to hold the sheet, keep press all the working time, special design on the hydraulic group
The In-feed Section of the machine allows for variations in sheet width
Pre-Level Device with 4 over 3 shafts to remove the Coil-set
Sheet feeding guide section with width variation
Powered feed in rolls
Hydraulic Pre-shearing device, manual control, only for cutting the first piece and the end piece of the sheet
Pre-cutting device, PLC control,
Hydraulic group, Pump motor = 4KW
Lubricating Device 1 set
Cold Rolling Mills
The feeding section with guide;
27-step to form
Wall-plate-frame-design,H beam base,with leveling bolts in the base to adjust the level
Rollers manufactured from GCr15, Heat Treatment, precision machined.
Shaft Diameter=95mm, Precision Machined, heat Treatment
Main Motor=22 KW
Forming speed approx. 0-15m/min
In correct operation & maintaining, the machine is guaranteed for one year since leaving our factory excludes the electric elements.
If installation is needed, WE will dispatch a technician to the buyer's factory abroad to assist regulating the machine with charge free. The buyer should assist US to get the Chinese technician's visa and should pay for the roundtrip air ticket and the local accommodation.
If installation is needed, the buyer shall make the following preparation before arrival of technicians.
Terms Of Trade
Package & Shipment:
Facility water-proof packing, Control cabinet packed in wooden packing.
30%payment by T/T is required as deposit within a week since the contract signing date.70% payment by T/T is required before the machine be send out of factory.